Post a New Reply
Reply to thread: How to change from Xwindows-Console
Username:
Post Subject:
Post Icon:no icon
Your Message: Smilies [get more]	[quote="Oroshi" pid='985' dateline='1073924600'] Default runlevel. The runlevels used by RHS are: 0 - halt ([color=#FF0000]Do NOT set initdefault to this[/color] ) 1 - Single user mode 2 - Multiuser, without NFS (The same as 3, if you do not have networking) 3 - Full multiuser mode 4 - unused 5 - X11 6 - reboot ([color=#FF0000]Do NOT set initdefault to this[/color] )   Most use 3 or 5 [/quote]
Post Options:	Disable Smilies: disable smilies from showing in this post.
Thread Subscription: Specify the type of notification and thread subscription you'd like to have to this thread. (Registered users only)	Do not subscribe to this thread Subscribe without receiving any notification of new replies Subscribe and receive email notification of new replies Subscribe and receive PM notification of new replies
Human Verification	Please tick the checkbox that you see below. This process is used to prevent automated spam bots.

Thread Review (Newest First)

Posted by grep420 - 2004-01-12, 06:22 PM

a shortcut, for the lazy:   perl -pi -e 's/id:5:initdefault:/id:3:initdefault:/' /etc/inittab

Posted by Oroshi - 2004-01-12, 04:23 PM

Default runlevel. The runlevels used by RHS are: 0 - halt (Do NOT set initdefault to this ) 1 - Single user mode 2 - Multiuser, without NFS (The same as 3, if you do not have networking) 3 - Full multiuser mode 4 - unused 5 - X11 6 - reboot (Do NOT set initdefault to this )   Most use 3 or 5

Posted by anyweb - 2003-12-11, 05:56 PM

How to change the default login to Xwindows to console or vice versa.   do as follows: open a console and login as   su -   then, as root type the following:-   cp /etc/inittab /etc/inittab.org   That has just copied (cp) a text file called 'inittab' to a new text file called 'inittab.org'. The reason for that is incase you accidently screw up the text editing that comes next ;-)       once done, type the following:-   vi /etc/inittab   that opens a pretty cool (or anal depending on how you think) console based text editor, and opens a text file. Use your up and down (and left and right) cursor keys to navigate the flashing cursor around this file. Scroll down to the line that reads:   id:5:initdefault:   ^^ yes that line there ^^   and change the number five (5) to a number three (3) so that it now reads   id:3:initdefault:   ^^ now it's a 3 ^^     If you find you cannot type the number 3, try pressing the INSERT key on your keyboard. (hint: pressing INSERT will toggle between INSERT and REPLACE mode, also, pressing ESC will CANCEL out of those modes and allow you to enter commands).   Once you have managed to get the line looking like this   id:3:initdefault:   press ESC to get control back, and press   :wq   Thats right, just a colon with a w (to write) and a q (to quit) ok, you are done !   now let's exit from X windows, easiest way is to reboot ! so go ahead and reboot, once you have rebooted you'll be presented with a console login prompt...   (to get Xwindows to load automatically at boot time change the 3 in /etc/inittab back to 5).