Linux-Noob Forums

Pages: 1 2

Quote:No one replies. Does it man those settings look ok?

weee.. I'll wave my hand at it ;)

Code:
route -n :

Kernel IP routing table

Destination     Gateway         Genmask         Flags Metric Ref    Use Iface

192.168.0.0     0.0.0.0        255.255.255.0        U     0      0        0 eth0

0.0.0.0         192.168.0.1     0.0.0.0                 UG    0      0        0 eth0

eeek .. where is your loopback? :x should have another entry like:

Code:
127.0.0.0       127.0.0.1       255.0.0.0       UG    0      0        0 lo

did you just not paste it?

Code:
lo Link encap:Local Loopback

inet addr:127.0.0.1 Mask:255.0.0.0

..

RX packets:259 errors:0 dropped:0 overruns:0 frame:0

TX packets:259 errors:0 dropped:0 overruns:0 carrier:0

259 ok.. so you might just not have pasted it

Correct this with .. if its missing!

Code:
route add -net 127.0.0.0

Code:
Router IP is 192.168.0.1[/quote]

[code]eth0 Link encap:Ethernet HWaddr 00:A0:24:89:04:F0

...

RX packets:10 errors:0 dropped:0 overruns:0 frame:0

TX packets:0 errors:0 dropped:0 overruns:0 carrier:0

hrmm . no errors .. and nothing receive.. i figure that you are able to send out..

Try this

Code:
ping -c 3 www.google.com

ping -c 3 66.102.9.147

The first will work if you have DNS and web.. the second will work if you have web.

And you can't ping 192.168.0.1? Do you have a 10 MBit card? If not try setting the mode manually using 'mii-tool -F 100baseTx-FD eth0'.

well, I didn't have loopback in my route. I tried to add it but I get an error:

SIOCADDRT: wrong argument

pings don't work

Yes, my card is 10Mb/s - its a BNC network

Pages: 1 2

znx

z0ny

grandzu